Pioneer 4 You vs. Sigelei
- Thread starter mlj381tx
- Start date
- th_trl_thread_readers 0
- Status
Same here ^. I have the Sigelei 100+ and never use the wattage. The only difference is the magnets in the door make changing batteries on the 100+ easier. The IPV is a little lighter.
If you want the one with the best build quality thus far with IMO the cleanest look i would say go for the sig100 plus. Fixed all of the problems with the 100w and the build quality def went up a notch. If watts are what you are chasing go for the IPV3 OR the sig 150. The firmware upgrading is only a big deal if you want to squeeze more watts out of the device, i personally stay around under 70 on my sig 100plus so it wasn't a big enough deal for me to sacrifice build quality for more watts. Plus the sig 100plus can actually be found for a bit cheaper than the IPV3, which is always a benefit.
Sig over P4U any day , unfortunately both warranties are handled by ASMODUS , the worst part of the whole deal by far .
I will have to say Sigelei all day. I have done a side by side comparison on the T8 by Cloupor, the IPV3 by P4U, and the Sigelei 150 and out of those 3 the Sigelei at 150 was the most obnoxious which leads me to believe that the others aren't putting out true numbers watts wise. The T8 at 150 wasn't much different than the Sigelei at 100 watts and the IPV3 at 150 was like the Sigelei at 130 so my thing is if you are looking for a high power box mod that is regulated and aesthetically pleasing the Sigelei 150 watt is the mod you are looking for it performs wonderfully it is very accurate with the ohms checker, which wasn't the case with the other 2 choices. Good luck and I hope you find what you are looking for.
- Status
