Plastic Needle Tip Bottle for eRoll

Status
Not open for further replies.

Hulip

Full Member
Sep 30, 2013
43
11
Jersey
Patkin,

The bottles from Mountain Vapor work fantastic. I have a stupid question though. How high am I supposed to fill this thing? The instructions were like leave a little room for some atomizer spike and I have no idea what that means!! Very new to this and want to do it right. Already disappointed though because I tried some Halo Liquid called Tribeca and it was awful! Tasted like apple chemicals or something. Will have to try this Johnson Creek bottle I also got.
 

izaidi

Senior Member
ECF Veteran
Verified Member
Mar 28, 2013
173
56
Toronto, Canada
It just means your pointy end of the atomizer (the silver thing that sits inside the eroll) goes into the cartridge. so if the cartridge is totally full so juice will spill out. just fill the atomizers almost to the top. your doing it right. its pretty easy, and nothing to worry about.

I hated tribecca too. its a RY4 variant. i actually hate all RY4's. take a while to find juices you like. but once you do, life is so much healthier than smoking.
 

patkin

Vaping Master
ECF Veteran
Nov 6, 2012
3,774
4,141
Arizona USA
Awe, sorry you didn't like your juice Hulip. My favs at Mtn Vapor are USA Mix, Cherry cured and Bacconut. I tried the two non-tobacco ones there and wasn't happy with either but then I'm mainly a tobacco flavor vaper and don't usually like anything else from any vendor. On the tank filling, if you're starting out with an unused atty, then its not important and you can fill all the way to the tope of the tank because the atty will suck up all the juice but if its already been used, it still has juice in it. Then you have to leave some empty space in the tank when filling or you'll get an overfill. Make sense? I'm not real good at explaining anything. :oops: When communication skills were passed out, I must have been absent.

Edit: Ooops... I love their Pecan Roll and its not tobacco... but the ones I didn't like were fruits.
 

Hulip

Full Member
Sep 30, 2013
43
11
Jersey
Thanks guys. Will try not to worry about it. I did notice a slight seeping from the cone and the tank. I don't know if its me not cleaning up after filling very well or if it does a little bit due to condensation? Haven't noticed anything down where the atty and the battery are so I guess I should not be too concerned except for my fingers getting a little sticky. Still new at this haha.. I figure I will get better with practice!!
I will look into Mountain Vapor some more I like that they shipped the bottles so fast to me so will check out the juices. Are the juices USA made? Im kind of a stickler to that. and do they carry the attys too? I figure I should order some sooner then later so Im not in trouble! ;)
 

izaidi

Senior Member
ECF Veteran
Verified Member
Mar 28, 2013
173
56
Toronto, Canada
Lots of great juices out there. Just have to find them. i find its very personal. stuff i like my friends hate. stuff they like i hate.

i prime a new atty before i put it in. not sure if it really makes a difference. but what i do is i put some drops right onto the wick of the atomizer until it wont absorb anymore. hope that makes some sense to you. you'll notice the first few drags off a new atty taste burnt. that's because the atty is still trying to absorb the fluid from your tank through the wick! i try to reduce that nasty first pull. maybe if i waited 10 minutes it wouldn't happen. but i usually start vaping right away.
 
Last edited:

patkin

Vaping Master
ECF Veteran
Nov 6, 2012
3,774
4,141
Arizona USA
Are the juices USA made? Im kind of a stickler to that. and do they carry the attys too? I figure I should order some sooner then later so Im not in trouble! ;)

Far as I can tell they do. Somewhere on the site they talk about hiring some fancy mixer who came up with their flavors. No, so far they don't. They really don't carry that much hardware. They're pretty small.
 
Status
Not open for further replies.

Users who are viewing this thread