Please help me drip

[daisybelle]

Hi I bought an ego-t type a atomiser cone to drip with. Except I have realised I have no clue how to do it?

Please help me

 

[martsumoto]

Just drip three drops on your atty and vape!
Only experience will let you know when it's time to drip again to avoid the bad flavor of the atty burning, depends also on the device and the juice, some might give you more puffs than others.

 

[FencingGirl]

I'm sorry, I can't help. In fact, my atty is on the way so I'm in the same boat. If you don't mind, I'll troll your thread.

 

[daisybelle]

Thank you, I can't get any vapour from it though when I dripped 5 drops into the cone. Grrrrr it surely is simple?


Sent from my iPad using Tapatalk HD

 

[antfuzz]

This is pretty old but nothing much has changed.

 

[DantesInferno]

Ya if you're atty is burning. Just drip into the atty and vape away. Nothing to it.

 

[recidivus]

5 drops may be too much (2-3 is usually plenty to get it started, 1 for top up after that) and you flooded the atty. This'll give you less a less than optimal vaping experience. I'm no expert, but how I tell if it's flooded is when I pull it "bubbles", and I get low vapour. Normally (don't have ego-t so don't know if it applies) I pull off atomizer, blow through it (a la carto) towards the battery end into paper towel a couple times, put back on and test. Clean up the battery connectors n such while you're at it too, software can pool up down there and maintenance never hurt. The other quick method I do is tilt the PV up...down...erm, battery end upwards around 45deg, and give 2 short pulls to get the juice back above the atomizer (don't tilt it too much or you'll get a mouth full of juice!). This doesn't fix the atty if it's very flooded, but if it's only a little flooded it should clear up.