Please help!!!

[Laguna6866]

I'm sorry if this has been posted already! Here's my problem- I use a nebula (Kr808d-1) PV. Whenever i use a new cartomizer, it works like a charm. However, whenever i refill it (10-13 drops) I let it sit for at least 24 hours, and the carto gets hot, and is very hard to draw. I only use PG liquid, so i don't think the liquid is clogging up the carto. This is very frustrating because i feel like I'm not getting my full moneys worth! I also have replaced my battery, so i know that is not the problem.

Any advice would be greatly appreciated! Thank you much everyone!!!

 

[jayhawk]

Sounds like maybe the hole needs cleared by spinning it or using a paper clip down the hole then spin it , that works for me if it's clogged up good luck

 

[Laguna6866]

Sounds like maybe the hole needs cleared by spinning it or using a paper clip down the hole then spin it , that works for me if it's clogged up good luck

jddehoff- thanks for the reply! Ive tried spinning the carto. can you explain a little more what you mean with "the paper clip down the hole"? Thanks!

 

[v1John]

[jddehoff probably means spinning it sideways, while the papaerclip is longways through the wind tunnel. There are two ways to spin it, and this is one of them, so it forces extra juice back outward towards the carto wall (away from the center). Only a few spins should do it, no need to spin too long or too hard]


Also, if it gets real hot, it could be that the wind tunnel is not exactly in the center, causing the carto wall to get real hot. The wind tunnel needs to be centered.

How? I don't know, but most of the time I "very' gently pull up on the filler material that is at the narrowest point, and that causes the tunnel to stay in the center a little better. Be careful not to push and pull the filler material too much tho. The tweezers I have are very small and extremely pointy, from the WalMart nail polish department.

 

[jayhawk]

Ya john is right , just bend a paperclip straight and put it through the hole and spin it like a basketball on your finger that will do just what John v1 explained plus keep that air hole clear and straight ..... Also leoford has a twirl method that you could look at it allows more juice to fill the cart