Pre Built RDA Coils

[LiamToomeyMusic]

any one used these before?? are they any good?

 

[KurrptSenate]

depends entirely what you are comparing them to. do you have any pictures of the actual coils?

 

[CptJYossarian]

I put the ones that came with PV clone in my friend's brass monkey and they're actually pretty damn good. Was about .24 ohms, so I'm guessing it was 24 ga kanthal micros.

 

[djsvapour]

I have some. Other than being the wrong resistance, they are fabulous.

I bought 1.5ohm ones and got 1.0ohm ones. fasttech, eh? What are they like.

 

[amtseung]

I put the ones that came with PV clone in my friend's brass monkey and they're actually pretty damn good. Was about .24 ohms, so I'm guessing it was 24 ga kanthal micros.

I build 30ga nano dragons at 0.25ohms. It may not be 24ga, but it's likely to be in that fatter range.
A prebuilt coil would take out all the fun of making my own, for me. I like my parallels, twisted wires, parallel twisted wires, asymmetrical parallels, zipper coils...

 

[Warpigs]

Welcome to ECF!

 

[Nightshard]

Not as good as the ones you can make yourself.

 

[timnixon]

I bought the Catterpillar RDA and then a few prebuilt coils.. I didn't care for them. They were tiny and had a braided wick, but were OK

I ended up buying some 26 gauge kanthol ($7 on amazon for 100 feet). At that price and watching a few youtube videos and a lesson from a friend I made my own.

It can be a bit of a hassle, but once you get pretty good at it then it'll take you like 5-10mins to do a build..

 

[Mark Nelson Jr]

Pre built by myself. I'd never trust anyone else coils specially if they from china ha

 

[TomGeorge]

I build 30ga nano dragons at 0.25ohms. It may not be 24ga, but it's likely to be in that fatter range.
A prebuilt coil would take out all the fun of making my own, for me. I like my parallels, twisted wires, parallel twisted wires, asymmetrical parallels, zipper coils...

how in the world do you get 30 ga kanthal to .25 ohms?

 

[plumeguy]

I don't see any problem using prebuilt coils until one gets reasonably good at making
ones own coils. 0.25 ohms doesn't seem right though.