Preferred EJuice Delivery system for Pipe?

Status
Not open for further replies.
Hello all,

My wife just ordered me a pipe from freightrainmods. WOOHOOO... Ok so now the question is what type/model of juice delivery system. I have tried a few tanks on my volcano and joytech but I have had no good results so far. Nothing but leaky, junky plastics becoming brittle, Constant bad coils and bad cartomizers (never used drip method).. Sooo... I would love to see what others are using. I am looking for something that is not going to leak everywhere as I wouldnt want it getting on my expensive pipe lol. So please if you have found something that is so wonderful that you would pick it over anything else (if you had to) post it up. Thanks so much to all and Happy Thanksgiving..
 

happydave

Ultra Member
ECF Veteran
Jun 2, 2013
1,580
684
United States
V3 Drip tip Adaptor
this ^ will allow the custom stem to fit on the device listed below
http://www.totallywicked-eliquid.co...nova-series/rcs-v3-clearomizer-2-product.html
im just guessing this might work well on your pipe mod...

if your tanks are cracking or etching is because of the juice your using. some flavorings contain an Ester group that will react with the plastic of the tanks. most vendors will tell you if the juice will crack plastic tanks, they will list and warning in the product description..
 

happydave

Ultra Member
ECF Veteran
Jun 2, 2013
1,580
684
United States
Thanks for the reply happydave. info on the site says that any tank up to 22mm in width will fit into the shank.
$5.76 Protank-2 BCC Clearomizer (3.5mL) - black / 2.4ohm / removable drip tip at FastTech - Worldwide Free Shipping
any idea on length? this is "fasttech" the prices are rock bottom, but things will take a long time to reach your mail box. some people have waited months... now that might take a while because clearing customs in there country just takes a while. there is a "fasttech" thread on here that will have more info if you decide to buy from this website... what i recommend you do is use the dimensions listed in the product descriptions for various atomizers and figure out what will work on your pipe mod.. then find a site that will have your desired atomizers already state side and ready for shipping. this way your not wondering for a month or two about your shipment.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread