I just picked up a Pro tank 2 and totally love it! I have a question though...is it normal to go through a tank every few hours? There are no leaks and the vapes are tasty and huge it just seems like I am going through a lot of juice. I was using a vivi nova before this and I know the tank is a little bigger but it would at least last me a couple of days. Any thoughts?
Pro Tank 2 Using A Lot Of Juice
- Thread starter clone1008
- Start date
- th_trl_thread_readers 0
- Status
Depends on how often you vape and how you vape.
Personally, I chain vape at work and easily go through a full tank in a few hours when there isn't much going on. I'd say it's normal, at least for me.
Personally, I chain vape at work and easily go through a full tank in a few hours when there isn't much going on. I'd say it's normal, at least for me.
MINE SEEMS TO GO FASTER THAN MY TOP COIL CLEAROMIZERS. I DONT HAVE HIGH VOLTS ON MY BATTERY EITHER. JUST A STANDARD EGO-C 650. dONT KNOW WHAT YOURE USING TO POWER IT BUT THAT MIGHT HELP TO DROP THE VOLTS.
No, that's just the bottom post. You can twist it all day long, it won't do anything. The only way to change the amount of vapor you get is either by raising your voltage or wattage if you have those capabilities, or by using a lower resistance coil. Or you can use a higher VG juice.
Vaping a week and got two Pro Tank 2's and two mini's. It seems I barely go through much juice at all. Maybe a tank every day and a half on the PT2. I was smoking just about a PAD and am vaping all day, on and off. Maybe some minor chain vaping here and there, but I'm definitely hitting it all day. Strange, but the juice seems to last me quite a long time. At this rate, vaping is MUCH cheaper than analogs!
I am using an ego-v v2 mega battery (VV) it is set at 4.3 using the 2.2 ohm coil. I'm vaping Halo Tribeca so I have no idea of the PG/VG ratio...they state it's proprietary info (Top Secret Ravioli stuff) LOL
Dont move that thing on the bottom that looks like a screw. You'll probably just screw up the internal wires of the coil and short it out. It's just a pin that holds the positive lead up against the rubber grommet. It doesn't adjust anything.
I am using the protank 2 2.2 ohm on a mvp 2 at 8 watts and I am also a heavy hitter but mine lasts about 800 hits on average.
I notice you're in San Antonio...I do training out your way for Cavendar Toyota & Fiat.
The setup, too. I vape through more juice on a mod than on an eGo.
The only reason for using more juice is that you vape more now because you like it more.
The longer you hold the button the more your using your device coil gets hot burns more juice; harder you draw the more your pulling juice to the wick.
I find myself holding my Vamo or whatever in my left hand and chain vape without realizing it especially when I'm on the internet.
Best thing that I found out was to remove all device's out of my arm's reach until I want them.
Just wait until you start recoiling them! You'll get even more performance out of a rebuilt coil with loads more flavor and vapor especially if you use cotton wick. I was so amazed at the amount of juice I was going through on a rebuilt wick! Worth every penny though for the better performance!
Well I guess I have that to look forward to....just ordered a Kayfun Lite....should be interesting!
I removed one of the flavor wicks and notice on my VV 4.2 is perfect.
I have the PT 2 also and it uses a lot less juice than my iClear 30's.... Those are juice hogs.
i just got my PT 2 and the only juice i have had with me was a pure VG. I took off the 2 flavor wicks because i was getting a burnt taste and that helped get rid of that ill try putting one back on. But so far I've been good with a tank a day.
Unusual, but nor unheard of. Suspect it has to do more with how you have adjusted to the PT2. All things being equal, the PT2 demands more inspiratory energy (and juice consumption) due to its rather airy, fluffy draw. The PT2 is a great tank though. Smart choice.
- Status
Similar threads
- Locked
