Problem w/ X Cube Mini and Subtank in TC

[Simpo]

Hey folks,

Have a problem that I have not been able to figure out or gotten a good answer about. My current setup is X Cube Mini with Subtank Mini with the new SC SS coil. When I try and vape in TC mode the coil burns hot after 1 sec and I get the "too hot" warning and system shuts down. The hit is burnt so I know something isn't right. I have the latest firmware installed on the mod and can't figure what the problem might be. The default coefficient setting on the Cube is .00100 for SC SS coils. Any thoughts on this problem or has anyone else had the same issue?

 

[suprtrkr]

I don't know anything about the Subtank, or any tank using prefab coils, but bump for an answer.

 

[Simpo]

I don't know anything about the Subtank, or any tank using prefab coils, but bump for an answer.

Thanks for the response. Not sure what "bump" for an answer means but I'm thinking the initial 200degrees setting is too low for SS so I'm going to try some different settings (temp, watt output, etc...) and see if that makes a difference. Will post a reply if I find an answer for anyone that may have the same problem.

 

[suprtrkr]

Thanks for the response. Not sure what "bump" for an answer means but I'm thinking the initial 200degrees setting is too low for SS so I'm going to try some different settings (temp, watt output, etc...) and see if that makes a difference. Will post a reply if I find an answer for anyone that may have the same problem.

"Bump" means run the thread back to the top of the list; it's on the page in chronological order of the last post to the thread. 200 degrees is low, if Farenheit. On the Centigrade scale it's about right. But it shouldn't burn like that.

 

[Simpo]

@suprtrkr Thanks for the response. I've now tried just about everything and getting ready to head to local vape shop to see if defective. Probably too late since I've had the device a while.

 

[Completely Average]

Have you downloaded the app for it? I don't have one myself but I've heard you need the app to set the parameters for SS coils correctly.