RDA Problem with new CLT Infinite RDA

[Roydub]

Picked up a new CLT Infinite today but having major issues with the post hole screws... There constantly coming loose, and because of that its causing the two coils to heat up at different times.. Not to mention I don't want the coils to become so loose that the coil itself shifts and causes a short..

This was the first coil set that I put on it so I am going to see if I run into the same issue with some different gauges... regardless, they shouldn't be coming loose on there own..

Has anyone had the CLT Infinite rda (or any other RBA for that matter) and run into this problem? If so were you able to fix it? What did you do?

Thank you

 

[SonHouse]

It sounds like you might need to tighten the screws, fire the mod a few times to heat the coils. Then let it cool and retighten the screws. If this is the problem, you'll feel them tighten down again when you exert the same amount of force you did previously. I've had similar issues with other attys.

 

[WharfRat1976]

Have not had the problems with mine. I am not sure, BUT the neg screws maybe a tad "different" than the posi screws. When I put a build on mine today I had to move the screws around- like 4 card Monte with screws. Maybe the screw sizes are a little off. Worth a try.

I cannot believe how high the coils need to be to be even with the airholes- Wicks are like a mile long but the vape and flavor is unreal.