problems with Airflow Control valve

[JTyler82]

So I picked up two of these today, and a few new heads for my Protank 2's...Uh...It's reading 0.0? I've tried pulling the pin out just a smidge, and nothing. I've tried adjusting my pin on my MVP, and still nothing. just 0.0. Even with my stock coil FROM my Protank 2's, it still reads 0.0

Help?

 

[jensy]

Keep trying to adjust your pin on the MVP whenever I have that problem it is on my device not the tank.

 

[cramptholomew]

Could be that the positive on coil head assembly isn't touching the aerobase. Try pulling the bottom pin out on the coil head a bit, and screw it back in.

 

[JTyler82]

Could be that the positive on coil head assembly isn't touching the aerobase. Try pulling the bottom pin out on the coil head a bit, and screw it back in.

Nope. Tried that. Someone suggested that over on Reddit.

 

[JTyler82]

Keep trying to adjust your pin on the MVP whenever I have that problem it is on my device not the tank.

Unfortunately i tried this. Still nothing

Mine is Flat on the bottom. is that normal?

 

[jensy]

Unfortunately i tried this. Still nothing

Mine is Flat on the bottom. is that normal?

If you can try and pry it up by the side ever so slightly it could work. I normally just use a pointed steak knife.

 

[TheAmazingDave]

Are you sure it's a real Kanger Aerobase? I was sold one that was an airflow control base, but not the actual Kanger piece.

The Kanger piece replaces the bottom of your Protank. A generic piece just screws on to the bottom of the stock Protank.

I had problems with mine as well.

 

[JTyler82]

Are you sure it's a real Kanger Aerobase? I was sold one that was an airflow control base, but not the actual Kanger piece.

The Kanger piece replaces the bottom of your Protank. A generic piece just screws on to the bottom of the stock Protank.

I had problems with mine as well.

Yep. It's Real. it srews onto to the bottom of my PT2

 

[JTyler82]

So I guess it's my pin. I just recently got a Vamov5 though, I just have to go pick up the package

 

[JTyler82]

Are you sure it's a real Kanger Aerobase? I was sold one that was an airflow control base, but not the actual Kanger piece.

The Kanger piece replaces the bottom of your Protank. A generic piece just screws on to the bottom of the stock Protank.

I had problems with mine as well.

Thought I'd let you know. It wasn't my base. my MVP pin is all screwed up. I Slapped it on my Nemesis, and away It went.

 

[wheelie]

Always when I switch head on MVP they don't work. have to give a good pull on the pin on MVP. My multimeter probe does it perfectly. Works everytime.

 

[TheAmazingDave]

Thought I'd let you know. It wasn't my base. my MVP pin is all screwed up. I Slapped it on my Nemesis, and away It went.

right on