I have a little dilemma on my hands here. I am a proud owner of two iTaste VV 3.0 batteries. I recently purchased the second one from fast tech. It came with some iClear 16's and I purchased some extra CE6 clearomizers below.
$2.23 CE6 Electronic Cigarettes Round Mouth Atomizer - translucent / 2.4
I started to vape on my older iTaste at first. The iClears work great, I had some good success with the cheap CE6's as well. The CE6's sometimes produce a burning taste but for the most part each vape was pretty solid.
I then decided to start using my new iTaste VV 3.0. Once again, it works great with the iClear 16's and the existing EVOD's that I had. Unfortunately, it HATES the CE6's I've ordered. I've tried 3 different CE6's on my new iTaste VV 3.0 and they all taste burnt. Every hit, they are all bad. I've played with the wattage and voltage but nothing seems to want to work.
It works better with my older iTaste though. They are the exact same model!. I'm considering trashing these CE6's. They were so cheap to begin with that I'll just pocket the $10 loss and forget I ever owned one. I do notice that the OHMS on the CE6 fluctuate. With the OHM reader built into the iTaste, I sometimes get 2.6 ohms, then I'll take it off, put it back on and it will now read 2.4 ohms. I've had it go as low as 2.1. This happens on both iTastes.
The EVODs and iClear 16s work fine. Isn't the CE6 a knockoff of the iClear 16? They look identical, but don't perform like the original. Does anyone have a recommended voltage I can try if the clearo is reading 2.6 ohms? I seem to have bad luck with the really high ohm coils.
$2.23 CE6 Electronic Cigarettes Round Mouth Atomizer - translucent / 2.4
I started to vape on my older iTaste at first. The iClears work great, I had some good success with the cheap CE6's as well. The CE6's sometimes produce a burning taste but for the most part each vape was pretty solid.
I then decided to start using my new iTaste VV 3.0. Once again, it works great with the iClear 16's and the existing EVOD's that I had. Unfortunately, it HATES the CE6's I've ordered. I've tried 3 different CE6's on my new iTaste VV 3.0 and they all taste burnt. Every hit, they are all bad. I've played with the wattage and voltage but nothing seems to want to work.
It works better with my older iTaste though. They are the exact same model!. I'm considering trashing these CE6's. They were so cheap to begin with that I'll just pocket the $10 loss and forget I ever owned one. I do notice that the OHMS on the CE6 fluctuate. With the OHM reader built into the iTaste, I sometimes get 2.6 ohms, then I'll take it off, put it back on and it will now read 2.4 ohms. I've had it go as low as 2.1. This happens on both iTastes.
The EVODs and iClear 16s work fine. Isn't the CE6 a knockoff of the iClear 16? They look identical, but don't perform like the original. Does anyone have a recommended voltage I can try if the clearo is reading 2.6 ohms? I seem to have bad luck with the really high ohm coils.
