Problems with smoketek dual coil using ego battery...help

Status
Not open for further replies.

DEATHTOCIGS

Senior Member
ECF Veteran
Verified Member
Jul 9, 2011
140
56
TEXAS
I just received a pack of 5 smoketek Dual Coil LR cartomizers from the vapingzone. I was excited to try and now I'm very dissappointed. When I screw them onto my ego battery I can't get any draw at all. I've tried loosening, but no good. They are firing but I can't pull out any vapor at all. Anyone else had this problem. Maybe they can't be used on an ego battery, I thought any 510 connection would work?

Found the problem, tried another from package and it worked good, comparing the 2 I found that the one that did not work was defective in that it had no air holes drilled into the collar under the threads. The one that worked had the holes. Wasted about 25 drops of juice, I'll be sure to check before filling another.
 
Last edited:

LostVapeMonster

The eyes are useless when the mind is blind.
ECF Veteran
Verified Member
Jun 7, 2011
3,109
20,596
57
Land of the Lost
Hmmm... I just had this same problem. Filled one last night and put it on my battery then... nothing. I have only tried one in the pack so far, though, and it looks like it has the holes you're talking about. Hopefully it's just a dud.
I just received a pack of 5 smoketek Dual Coil LR cartomizers from the vapingzone. I was excited to try and now I'm very dissappointed. When I screw them onto my ego battery I can't get any draw at all. I've tried loosening, but no good. They are firing but I can't pull out any vapor at all. Anyone else had this problem. Maybe they can't be used on an ego battery, I thought any 510 connection would work?

Found the problem, tried another from package and it worked good, comparing the 2 I found that the one that did not work was defective in that it had no air holes drilled into the collar under the threads. The one that worked had the holes. Wasted about 25 drops of juice, I'll be sure to check before filling another.
 

bruiser

Ultra Member
ECF Veteran
Nov 20, 2010
1,257
291
Louisville, KY
Apparently there is a problem with the emdcc. The battery center post is not long enough. You either have to pull it out, or raise the battery center post. The other solution, as previously mentioned, is the 510 shorty extension. I've also read about some people shaving, milling, sanding, or cutting a small amount off the battery end of the carto.
 
Status
Not open for further replies.

Users who are viewing this thread