Protank 2 issues

[CallmeRage]

I tried to clean my protank 2 and its impossible to take apart. Any tips or tricks i can do here? Thanks

 

[CBone8408]

You can put electrical tape around some channel locks to prevent scratching and unscrew the top form the bottom if that's your issue. Hope this helps

 

[Sarin]

Unscrew the bottom section (the bit that holds the atomiser), then unscrew the next silver bit, this is short and stubby, leaving the silver tube in the glass. Next remove the drip tip and gently prise the glass from the silver top ring When you replace DO NOT tighten the bottom ring too much or you'll crack the glass. (Rubber gloves can help if it's being a bit stubborn).