Protank Setting

[soba1]

I have a head registering 2.1 ohms on my protank. What would be the highest and lowest settings y'all would recommend?

thanks

 

[PONKAW]

I think it is going to come down to your personnel preference. What type of juice you use will be effected by the voltage. I rebuild my heads at 2.0 almost exclusively and usually vape lighter non-tobac juices...
For my set up I use anything from 3.7 to 4.2 volts... anything lower is quite week and anything higher tends to taste burnt. But again your juice plays a big part in this.
YMMV

Don

 

[eratikmind]

I suggest start at 3.5 and adjust up to suit your own individual taste, as there is no definitive setting.

- Andy

 

[iuwg1vet]

I agree with the previous posts. It is very subjective.

 

[soba1]

Thanks just don't wanna burn up my heads to fast....
Last question, please if anyone would...
Why do some people prefer higher ohms as opposed to the lower ones?
Thanks

 

[eratikmind]

Thanks just don't wanna burn up my heads to fast....
Last question, please if anyone would...
Why do some people prefer higher ohms as opposed to the lower ones?
Thanks

All depends on whom to speak with. Last week, I was at a local vape meet. Most of the kids were running very low sub ohm dual coil dripping atties. I moved to the other side of the room.

When regulated, I like mt coils coming in at 2.0Ω to 2.5Ω. Non-regulated, I like my coils between 1.2Ω to 1.5Ω.

- Andy

 

[soba1]

All depends on whom to speak with. Last week, I was at a local vape meet. Most of the kids were running very low sub ohm dual coil dripping atties. I moved to the other side of the room.

When regulated, I like mt coils coming in at 2.0Ω to 2.5Ω. Non-regulated, I like my coils between 1.2Ω to 1.5Ω.

- Andy

Unregulated lower ohms more vape.......?
Regulated higher ohms more vape?

 

[bikerbeagle]

Try this: Ohms Chart

 

[timinftl]

Everything's pretty much been said, it's pretty much an individual thing. You can pretty much go simply by taste and temprature.
If your hit is too weak, slower draw or higher heat. If it tastes burnt or your connection area/head area is getting very warm then most likely too hot.
JM2CW

Thanks just don't wanna burn up my heads to fast....
Last question, please if anyone would...
Why do some people prefer higher ohms as opposed to the lower ones?
Thanks

 

[kas122461]

You should also do a search, in the forum for pro-tank, there are a bunch of threads, you should read about this tank, also rebuilding the coils for this are easy!

 

[soba1]

Try this: Ohms Chart

Thanks lol you know I have it bad I have it saved to my cell as a pic.
But this is what confuses me.....

 

[soba1]

You should also do a search, in the forum for pro-tank, there are a bunch of threads, you should read about this tank, also rebuilding the coils for this are easy!

Thanks will do. I even got brave enough to take one of the wicks out of my heads.
Thanks everyone