Hey fellas, I tried doing my boys aga atty. but it's not working out. I'm getting E1 and E2 on the provari. I thought it'd be a simple set up. But I don't know what I'm doing wrong here. I did a 3/4 wrap and a 4/5 wrap. The 4/5 works but its at a .9 ohm reading. The battery is fully charged and provari is pretty much brand new. I have a 28g Kanthal with a 325 mesh. Would like some help. Thanks
Provari and AGA 2 genesis
- Thread starter Jeprox89
- Start date
- th_trl_thread_readers 0
- Status
Your coil has too low of resistance. The Provari has a 3.5 amp limit, anything over 3.1 volts on your .9 ohm coil would cause the E2 errors. Unfortunately you aren't going to be able to go super low resistance on the Provari, if that is what you are trying to accomplish. I would say wrap your coil 5/6 or 6/7 wraps, your coil should come out around 1.3-ish, and you'll be golden.
I got an E1 error on my Provari and couldn't figure out why because the atty would work fine on another mod. Then I looked up the code and discovered that I had the voltage set too high so even if you make a coil around 1.5 ohms, if you have the voltage set too high you'll get an E1 error. Just food for thought.
- Status
Similar threads
