Grooovy, that i dont mind. every 45 minutes just might drive me nuts'.
thanks Cba . heh
Meems
thanks Cba . heh
Meems
I think you should be ok for a couple hours.
I think you should be ok for a couple hours.
Did we discuss this already? because my minds done in', but did I ask what you all thought of someone who almost chain vapes, (meaning: i'm not going to admit completely that i chain vape), but how long do you think the 18350 batts would last me? like 2 hours? or maybe more?
thoughts?
I know this is apple vs orange,but the AW IMR 18350(700mah)lasts me around 5 hrs. in a different vv device that uses them
I use a 2ohm carto tank at 4..2v
Im a chain vapor too. I vape probably 6-10ml a day. Id say it should last about 6-8 hours ,maybe a little more. 18490's i get about 8-10 hours and 18650's i get about a day.Thats just a rough estimate. I vape at 5v with a boge sr most of the time.
I was thinking the chain vaping thing. I guess the best way to gauge it would be how many tanks. I think you'd be able to get through 3-4ml of juice pretty easily, but that's just a guess. Most of my mods are stackedI know this is apple vs orange,but the AW IMR 18350(700mah)lasts me around 5 hrs. in a different vv device that uses them
I use a 2ohm carto tank at 4..2v
pay attention to how much juice as well.I"m going to time it, i'll put down the time right when i start and then when the battery dies, i'll jot the time down. this will be fun.
pay attention to how much juice as well.
I"m going to time it, i'll put down the time right when i start and then when the battery dies, i'll jot the time down. this will be fun.
If you find your battery time isn't exactly what you were hoping for, you can extend it depending on what gear your vaping with.
If you use a higher ohm carto/atty at a higher voltage vs a lower ohm carto/atty with a lower voltage to come out to the exact same wattage (heat), it will use less amps and make the battery last longer. I'm not sure exactly how much longer, but I get about 2 days off an 18650 (1.5 to 2 ml per day) on a boge 3.0 carto at 4.8 - 5.0v and slightly less than a day if I use the 1.8 ohm atty at 3.6 - 3.8v. Oh and my days are usually 18-20 hrs long.
i'm on the dcc/tanks, the map tank thingy with the dcc inside. i'm on the lavatube right now, man i hate the lt with dcc/tanks, thats why i was soo excited about the prov mini, the LT lowers the voltage on almost every puff. pathetic piece of machinery if you ask me...anyway, where was i?..oh yah, so always on dcc/tanks, 6ml or 3ml, and i dont have a choice right now, i'm stuck at about on average 3.5 volts. but i want to be around 4.7 volts. now whats the math on that oh great one'? heh
Meems

OH my gaaa, your scary. wow. thats impressive, not the volts but YOU.
So best to get the 1.5ohms. okay thats what i'll do. i actually got the higher ones 2.5, because the 1.5's suckkked with the LT
Thanks Envith!
Anytime.You can still use the 2.5 just up the voltage. Let me check...
Yeah, so with the 2.5 version, try 6volts. Again, high ohm = longer battery life. So at 6 volts, you get 14.4 watts (7.2 per coil) at 2.44 amps. Too bad you couldn't try 6.1, put you closer to the same wattage as 4.7v on the 1.5 ohm.
6 volts? wow thats not going to fry my throat? lol
Nah, not if you have a 2.5 dcct. I do suggest that you set your provari at 3.7 to start and do a ohm check (Ao on the provari menu, think it's 13 clicks in) and verify before raising your voltage that high. It's all about the watts on how hot the vape gets.
I made a few edits to that last post. Wanted to add one more post to the thread asking forgiveness for hijacking the thread for a bit.![]()
Any schedule for the black satin mini?