Ptn04050 testing- is this right

[inkjet21]

yes i did fix the problem, it was the battery's. i just got my new flames battery's and they work great. as far as the 200k pot goes it dose work but it was more for testing and not to use in the mod the volts go way to high with the 200k pot it ranges from 5volts to 15 volts i ended up just using a 147ohm, res. to get 5.2 volts and that works well for my ry4.if you look on the spec sheet you will find this
5 V Open
5.2 V 147 K
5.4 V 72 k
5.6 V 47 k
5.8 V 34.5 k
6 V 27 k
and for me anything over 5.2 volts is just to hot.i use the 147k for my ry4 but everything else i remove it and run it open with a 2.7ohm atty and its relly nice.

 

[inkjet21]

also if you do want to use the higher voltage you just need to get higher ohm attys if you get some 4 or 5 ohm attys you could get up in the 6 volt range and be ok i think.