Hi all, just purchases a doublepack of Puffaway e ciggies last weekend. Worked fine on Sunday after the initial charge up period, but since Tuesday the damn end flashes every time I take a second puff, even if I leave it alone for 15mins or so.
Any suggestions of what I could be doing wrong?
A couple of possibilities.
1. Your battery is not fully charged
2. You baterries Protection Circuit Board (PCB) is sensing a failure cutting power.
3. Your Atty may have gone to the high side on resistance causing the PCB to think there is an excessive power drain.
Try re-charging the battery, then try a different atty. If it only happens with that one atty then the atty may be going bad, check the ohms resistance for higher then 3.4 ohms i.e. (10+). If it has high resistance send it back in for replacement.
If it only does it with that one battery then there may be a fault with the protection cicuit or battery. Send that battery in for replacement.
Hope this helps
Dan
