Pulse 24 single coil setup

[burningace766]

So I’m building a coil for my pulse 24 to be ran in single coil mode ,and I was wondering if it’s alright to build across the holes in the bottom of the deck.What I mean is that there are 2 sets of 2 screws for the positive and negative ends of the coil,and if I was using 2 coils I would put one on the left and one on the right set of screws.Is it okay to use one on the left and one on the right for a single coil?I can attach pictures if this doesn’t explain it properly.thanks

 

[bombastinator]

If I correctly understand what you’re saying , yes.

 

[burningace766]

If I correctly understand what you’re saying , yes.

Essentially what I’m trying to say is I would be using one positive and one negative end (obviously)but just on opposite sides.I figured it would be fine but I just wanted to make sure.

 

[suprtrkr]

Hi and welcome. I don't have that machine, but it appears to be a fairly standard postless type. Yes, you can build across the holes. Make sure the coil is well clear of the deck as the deck is the "posts" an make electrical contact.

 

[Mr. Relentless]

Positive and negative are totally separated from eachother. Your negative is grounded to the entire atty even if they are separate they are connected to each other and the whole rda. And the positive is one piece separated off your atty.

 

[Mr. Relentless]

In all reality you can disconnect your negative and run it through a air hole and clamp it down and it will work. So you are fine.

 

[bombastinator]

That’s the normal way to do it . You’re good I think