Pure VG in a tank? No problem!

[CherryMedic]

I have started to vape pure VG out of my tank. I won't bore you with why.

Anyway, most vendor's 100% VG liquids are too thick to vape without some rudimentary alchemy (adding some distilled water) or punching the hole bigger with a saddle valve. Due to my lack of experience in both of those genres, I usually end up flooding my carto.

HOWEVER!! There is hope!!!!

Alien Visions carries pure VG juices that vape beautifully out of my STOCK tank from altsmoke with a 1.5 ohm tank cartomizer. I have done nothing to the juice or the tank and have absolutely no problems. I wanted to share this because I consider this a really great discovery!

Here is my silver bullet with a hefty dose of Boba's Bounty. Have a vapelicious day!




Sent from my iPhone using Tapatalk

 

[Vap3Go4t]

First off, beautiful SB. I have the black with black button and a black 6ml dct.
I like pure vg so that's a good find. Do all their vg juices work good in the tank?

 

[CherryMedic]

I have only tried bobas and raf-a-licious... but have not had a problem with any of them. I plan on buying Gorilla Juice next.

On a side note, I have heard that some juices can degrade a polycarbonate tank. I have had no problems with this when using any of their juices. I have had their juice in two different tanks for about a week now with no evidence of degradation.

p.s. thanks for the comment regarding my SB. I like it a lot

 

[ZedPM]

Hi CherryMedic,

Nice setup!

Thanks for the info on VG juice I want to try it next.

I plan on purchasing these next for my torpedo. Until I get them I'm dripping and wow! juices taste so good.

If it will fit try these with the VG:

3.5ML Dual Coil Tank - Single

"Polypropylene is considered more stable with different e-liquids than the polycarbonate tubes"

~Zed

 

[Vap3Go4t]

Btw cherry, what volts are you running and which batteries did you get?
I am using a aw imr and regular aw 18650, I like the aw imr better. I'm going to go 6 volts soon but wanted to start lower just to test it out.

 

[CherryMedic]

I'm running an 18650 and it does the job. I thought that was the most we could run in that unit

 

[Vap3Go4t]

That's the most they "recommend" but a lot of people use the 2 stacked 3 volt rcr123 a's to make it a 6 volt device. If you do you need to get a higher ohm atty or cart for your tank. It's supposed to be a better flavor and th on 6 volts.

 

[CherryMedic]

I have been using the lowest ohm possible because I was led to understand that the 1.5 ohm, although short lived, provided the highest performance

 

[kabonk]

I DIY 100% vg and don't cut it with anything it's pretty thick and use a carto tank on all my VV tube mods I've never have an issue