Question about DIY e-liquid from healthcabin.net

[rep1977]

I recently ordered some liquid from Healthcabin Electronic Cigarettes - Wholesale and Retail so I can try my hand at DIY.
I bought a 115ml bottle of 24mg/100% PG as well as a 115ml bottle of VG.
I just mixed both bottles together to cut the nicotine to around 12 mg, I know it will be a little less once I add the flavor.

I have 2 questions.

1) Is it normal for the liquid to look cloudy?
2) How much flavor would I add to 10ml of liquid?


Thank you in advance!!!

 

[Bangtango]

Check and see whatever site you ordered your flavoring from and they might have advice on how many drops to add. Also check the DIY section and research. Sorry I can't help you more than that as I've never tried it...but am curious about it.

Also curious about ordering from healthcabin. How much did shipping cost you and how long did it take to receive it?

 

[dchest02]

There are far better places to order DIY supplies here in the US. (Check the DIY section) To answer you questions though.

1. I have never had my DIY juice look cloudy, except for when I shake the bottle to mix the ingredients
2. It depends on the flavorings you are using. Most DIY flavorings I mix around 10% to start. But some places offer super concentrated flavorings that should be mixed at 2.5% to start.

 

[Petrosino]

Hello, it depends on the flavour, if it's too strong it's normal to put around 5 drops in 10 ml bottle, but if it's not so strong, as some FA flavours, you need to put about 7-8 drops to make it right. I am using e-liquids to create my own DIY. Because i prefer stronger flavour, i am putting around 10-12 drops in a 10ml bottle. But if you are using only VG LIQUID, you know it's sweeter than the PG so the taste is not so clear as in the PG ( you need to put some more drops) I hope i was helpfull. Enjoy the vaping

 

[hvac999]

I have dealt with Health Cabin alot since 2010. They have good customer service, but it just takes so long to get their stuff since they are in China.

 

[tdtyler]

I recently ordered some liquid from Healthcabin Electronic Cigarettes - Wholesale and Retail so I can try my hand at DIY.
I bought a 115ml bottle of 24mg/100% PG as well as a 115ml bottle of VG.
I just mixed both bottles together to cut the nicotine to around 12 mg, I know it will be a little less once I add the flavor.

I have 2 questions.

1) Is it normal for the liquid to look cloudy?
2) How much flavor would I add to 10ml of liquid?


Thank you in advance!!!

Cloudy would bother me unless it clears up after sitting for a while. Just my 2 cents...

 

[shawnjls]

How much flavor would I add to 10ml of liquid?

0.5ml flavor + 9.5ml juice = 5%
1ml flavor + 9ml juice mix = 10%
1.5ml flavor + 8.5ml juice mix = 15%
2.0ml flavor + 8ml juice mix = 20% (my personal FAVE)

 

[rep1977]

Check and see whatever site you ordered your flavoring from and they might have advice on how many drops to add. Also check the DIY section and research. Sorry I can't help you more than that as I've never tried it...but am curious about it.

Also curious about ordering from healthcabin. How much did shipping cost you and how long did it take to receive it?

Shipping cost wasn't too bad, but it did take like a month or so to receive.