QUESTION about my mini pipe

Status
Not open for further replies.

ROB26

Senior Member
ECF Veteran
Jan 27, 2009
128
0
Fort Worth TX
Hello all, I recently purchased a mini pipe and am having some problems. When I first got it, it worked just fine; however, I boxed it up for a few weeks and didn't use it at all. Last night when I got it back out to use it again I encountered a strange problem. When I put the battery in and close the top, the red light blinks a few times then stops, then, when I try and take a puff, it blinks some more, no vapor. And every time that I attempt to take a draw it just continues to blink, NO VAPOR....this is getting quite frustrating...anyone have any ideas on why this could be happening? I would greatly appreciate any advice...thanks!


:confused:
 

ROB26

Senior Member
ECF Veteran
Jan 27, 2009
128
0
Fort Worth TX
I don't have a pipe but it sounds like your batter drained while you wern't using it. Charge it up.

I assumed that was the problem as well; however, when I put my battery on the charger, it remains green, I'm charging the second battery as we speak...I'm hoping that solves the problem.

When I put the battery that I am currently charging in the mini pipe, nothing happens at all...I would assume that it should work with even a little bit of a charge, but so far that isn't the case....strange
 

smokindeuce

Unregistered Supplier
ECF Veteran
Sep 22, 2008
1,417
13
UK
www.smokejuice.co.uk
Hi Rob -

The only thing I can think of - and this may be very obvious, but are you sure you have put the battery in the right way?

I only suggest this, because the batteries don't have clear indications of which is the positive/negative end.

I tested this theory (do not attempt!!) out by putting it in the wrong way and the light will still likely come on, but little to know vapour will appear.

By doing this, you are more than likely to short circuit the pipe and ruin the switch so make sure you have placed the battery in the intended way!
 

smokindeuce

Unregistered Supplier
ECF Veteran
Sep 22, 2008
1,417
13
UK
www.smokejuice.co.uk
No problem Rob.... actually the latest batch of batteries seem to be getting some info printed on them now ie. voltage, model etc - I'm pretty sure they had the +/- signs on now as well but haven't got any to hand...

EDIT: The positive end of the battery is the slightly raised button surrounded by a white tape and the button has three holes in it. This goes at the top.
 
Last edited:

ROB26

Senior Member
ECF Veteran
Jan 27, 2009
128
0
Fort Worth TX
No problem Rob.... actually the latest batch of batteries seem to be getting some info printed on them now ie. voltage, model etc - I'm pretty sure they had the +/- signs on now as well but haven't got any to hand...

EDIT: The positive end of the battery is the slightly raised button surrounded by a white tape and the button has three holes in it. This goes at the top.

yeah, I figured it out after a little examination, but I sure was baffled at first...lol...good to know they are in the process of resolving that issue!
 

sanneke

Moved On
May 28, 2008
816
3
USA
Hello all, I recently purchased a mini pipe and am having some problems. When I first got it, it worked just fine; however, I boxed it up for a few weeks and didn't use it at all. Last night when I got it back out to use it again I encountered a strange problem. When I put the battery in and close the top, the red light blinks a few times then stops, then, when I try and take a puff, it blinks some more, no vapor. And every time that I attempt to take a draw it just continues to blink, NO VAPOR....this is getting quite frustrating...anyone have any ideas on why this could be happening? I would greatly appreciate any advice...thanks!


:confused:



Rob, I have two mini pipes.
One of them has the same problem.

It flickers when I pick it up, so you can't take a puff.

I talked to some other people, they suggested that the battery is too loose.
In other words the lid is too high for the battery to fit snug.
The other thing is that when I pop the lid off, the battery seems to be stuck in the pipe.

I tried to put a piece of tape around the pipe, top under to bottom.
That solved the problem.
It's a little of a pain, because when the battery is empty, you have to take the tape off.

I also tried to bend the little silver hooks on the side at the top of the pipe.
That did not work either.
 

ROB26

Senior Member
ECF Veteran
Jan 27, 2009
128
0
Fort Worth TX
Rob, I have two mini pipes.
One of them has the same problem.

It flickers when I pick it up, so you can't take a puff.

I talked to some other people, they suggested that the battery is too loose.
In other words the lid is too high for the battery to fit snug.
The other thing is that when I pop the lid off, the battery seems to be stuck in the pipe.

I tried to put a piece of tape around the pipe, top under to bottom.
That solved the problem.
It's a little of a pain, because when the battery is empty, you have to take the tape off.

I also tried to bend the little silver hooks on the side at the top of the pipe.
That did not work either.

That sounds exactly like the problem I'm having....battery definitely gets stuck in there! I appreciate your insight and will give your tape idea a try for sure...We'll see what happens! Thanks again!:cool:
 
Status
Not open for further replies.

Users who are viewing this thread