Question about my new Kanger T3 - not getting much TH/draw

Status
Not open for further replies.

Bubba

Super Member
ECF Veteran
Verified Member
May 3, 2010
655
730
North Carolina
Hello everyone

Just getting back into vaping and so far so good. Ordered a starter kit that came with 2 CE4 clearomizers, (which have worked great so far), then ordered 2 Kanger T3's for the increased capacity and based off what I've read here.

Sooo

Got the Kangers in the mail along with some more juice, filled one about half way and...

disappointment

These seem to be letting too much air in, and not enough vape. Reading on here, I saw where someone plugged one of the holes along the bottom and that made everything better. I covered two of the hole (which helped) but still not up to the level of my clearomizers that came with the kit.

My battery is 900 mah VV and I've tried every setting but can't seem to find the sweet spot to get a good TH and decent amount of vape

Finally I dumped one out and put the juice I've been using all week in it, and that has helped.

So I'm wondering if this is just how these things are, or could be the juice needing to be steeped, or could need a higher voltage. Or all 3

Also, I've been using 24 mg 50/50 PG/VG (edited to add this)

Let me know what you guys think

Thanks!
 
Last edited:

Tajji'smom

Super Member
ECF Veteran
Dec 31, 2012
489
922
Southern Ontario
I was the same as you- wanted more volume. They say to take the top wick off for better flavor and it takes a little bit to break in. I've had leaking problems since I took top wick off. So I cleaned it and left it for a couple days and fluffed remaining wick and works fine now. I still don't like it. I went back to my Ce3's for the best flavor. I'm not crazy about the drip tip either. I'm going to wait for the next version
 
Status
Not open for further replies.

Users who are viewing this thread