Question about VMOD

Status
Not open for further replies.

ecitek

Super Member
ECF Veteran
Feb 16, 2010
318
163
Earth
I have been using a homemade bottom feeder for a long time. I think I am going to buy a VMOD 2.

On the website it says "It's also compatible with any modern 510 cartomizer". Why doesn't it say "Atomizer"? Why would you need a cartomizer with a bottom feeder? I like the Bauway 510 LRs and would like to be able to use them on the VMOD.

Does anyone have experience with atomizers and the VMOD-2?
 

ecitek

Super Member
ECF Veteran
Feb 16, 2010
318
163
Earth
Are there any special o-rings or setup required to use a 510 LR atty?

I am looking at the 2.0, but the XL looks nice - just seems kinds large. The website doesn't really give the measurements too well. Could someone post the dimensions (HxWxL) of the XL, minus the atty?

THANKS for the help. Need info 'cause I want to order today or tomorrow.

Also - Are the Silos carts any good? I normally use a 1.5 LR - how do you like the 1.8 Silo?
 

Horseman9

Ultra Member
ECF Veteran
Verified Member
Mar 10, 2012
1,035
2,440
Colorado, USA
Are there any special o-rings or setup required to use a 510 LR atty?
Could someone post the dimensions (HxWxL) of the XL, minus the atty?

Had to run to the garage for a tape measure. 4 5/8 tall at nose cone, 1 3/4 wide. That is with the LR 306 in. Standard atty would just add your drip tip height. No O-rings needed - they are part of the design. Never tried their atty/cart - I like the LR 1.5 ohm 306 - lotsa vapor/flavor
 

Icig

Senior Member
ECF Veteran
Verified Member
Mar 7, 2012
203
34
Idaho
My Vmod 2.0 works great but has a small learning curve. Their hybrid 2.0 ohm attys work great but once I get my vid up on it you should watch it as I show a way to fill the bottle without taking it off. When you take it off about two times the threads become ruined and you need a new bottle.


Sent from my iPhone.
Volt
Magma
Inferno
Lava tube
Vmod 2.0
Reo Mini
Ikenvape
Cherry vape
Empire mods
Pink Spot Vapors All The Way!
 

ecitek

Super Member
ECF Veteran
Feb 16, 2010
318
163
Earth
Just got my 2.0 today. When I removed the ring (that goes around the bottom of the atty) there was an o-ring kinda jammed in there - kinked up and in no particular place. There was an o-ring on the ring as well. Cannot tell if this is an extra o-ring or if it was just installed improperly. In the pic below you can barely see the o-ring inside the chamber.

Is this supposed to be installed inside the chamber somewhere or is it just an extra they included?

100_1819.JPG
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread