Quick question

[GTItuner]

Hey all
I recently got a chip that I bought off of eBay and wired it all up and threw it in a box. It vapes great the only problem I have is that It has a built in voltage read out and it stays on the entire time I vape unless I turn the main power switch off. Is there any way to get it so that when I hit the button it comes on only?

It's just a pain to flip the main power switch after every drag to save battery life

 

[slimest]

I think, the easiest way to do that is use a powerful button instead of main switch. Mechanical button or mosfet.

 

[GTItuner]

So instead of wiring my button to atty and positive out I would going from battery ground to input ground?

 

[slimest]

Either ground or positive input.

 

[GTItuner]

Great ill try that
thank you !

 

[BJ43]

I have found that this is the best way to wire the meter. It gives both static and load readings on the batteries and the atty, also completely off if you don't want to draw attention with the light on.

 

[notsmoking]

I have a couple of those type reg's and what you need to do is attach your positive from the battery to your button switch and then the out side of your button switch to the in voltage on the reg....... that way your led reading will only come on when you push the button for a toot. Also that way no voltage is used. Also just remember that the white push button on there will give you battery voltage in one position and your atty voltage when in the other position..