RBA's and the Darwin

[Lumiis]

Are there any Rebuildable Atomizers that work (fit) on the Darwin with the arm closed?

Anyone here have rba + Darwin experience?

Thanks! ~Lumiis

 

[Drewsworld]

This fits most Darwins with one or two 510 to 510 extanders...
The Phoenix Style Rebuildable Atomizer

 

[Lumiis]

I appreciate the quick response Drew, any idea the lowest ohm that the Darwin can handle safely?

 

[Drewsworld]

I wouldn't push the envelope with too low but it will give you a warning if its too low...Im not really sure what the exact limits are though...

 

[Killjoy1]

The board maxes out at either 5 or 6 amps (can't recall which offhand) and will give you a little screen icon indicating an atomizer short (there's a pic of it somewhere in the ginormous Darwin thread)

As Drew said, though, I wouldn't push it too far as the device will shut down to protect itself under certain conditions and may then need to be serviced to get it running again. If you go too low with your ohms for the wattage you're set at, then it'll just push out straight battery voltage. IMHO a good rule of thumb would be to keep your resistance within a range where you are still allowing the board to boost the battery voltage, this way you're not overly stressing anything (either the board or the batteries)