RDA - First Dual Coil Build - Errors

[SkoOtz.DC]

Hi guys,


So this was my first dual coil build. I put it on to test it before i went to pulse it just to check it out and i got a reading of 608. I played with it. No coil is touching the deck. No coil is touching a post or side wall. This is my 2nd attempt and the exact same thing happened last time.

The rda is new but i was vaping it fine this afternoon with a single coil.

 

[SkoOtz.DC]

I tested each coil individually and they came out to 1.2 and 1.26.

 

[alkaiser]

your ohm meter is reading .608

some meters stop displaying the decimal once it reaches sub ohms

 

[steel bender]

^^^what he said^^^

Did you forget to plug it in? I hate to be that guy, but I see the post holes. Sometimes if they're to loose, they'll unscrew, or to tight and they'll shear off the wire.

 

[SkoOtz.DC]

Oh snap! I feel a little stupid now. Haha thank you, that explains it, because i rebuild it with higher resistance at it worked. Thank you