Okay so I've owned my first rda for about a week, managed to drop it one singular time and now it won't fire. The RDA itself is a CCI Archon 3 post set up with removable center pin sitting on a Windrose clone mech mod. I know it isn't the mods fault since it will still fire my nautilus Aspire tank. Also whenever I put the RDA on my vamo it's giving me a readout of 9.9 ohms when I check the resistance. Tried taking the Archon apart, cleaning each piece then reassembling to ensure everything was snug but I'm still having the same problem each time. Any advice would be GREATLY appreciated since I've been doing this for the past 3 days and really don't want to take it to my local vape shop since they're prices are so steep.
RDA troubles...
- Thread starter Shaggy830
- Start date
- th_trl_thread_readers 0
- Status
Hello Shaggy 
How are your coils in it? they might be shorting it out? or if they are loose in the post they would give off readings, or maybe screwd down to tight and broke one of the coil legs? or one of the posts are bent in?
How are your coils in it? they might be shorting it out? or if they are loose in the post they would give off readings, or maybe screwd down to tight and broke one of the coil legs? or one of the posts are bent in?Hi Dextrose, I've tried two separate sets of coils and neither have given me any different readings, the legs of the coils are slightly bent from where I've been putting them back in repeatedly but they haven't been broken. The negative posts haven't been bent as far as I can tell and I've replaced the center post since it came with a spare but to the same effect.
- Status
Similar threads
