Rebuildable attie for a newbie...advice wanted

[Plumes.91]

so the Ody PV is made by Imeo as well as the GG line of PVs, correct? Is there just an Odysseus Genesis atty or is there also an Odysseus PV? I think I know this but I need to make sure haha.

+1 for using MESH with your vivi nova, also, the DID, the DID clone (which can be found in stainless OR chrome, be sure to note that when ordering so as to match the finish to the PV you plan to use it with) The DID also comes with a CLEAR tank. Then there are also RBAs with NO tank and instead, a shallow juice well. These include the bully, the rainbow, and the pheonix. Some models of the bully were made for use with the ego-t cartridges too so be weary of that. The vivi nova tanks are your best bet because if you device rebuildng is too much of a pain in the bum, you can buy the coil heads. However, if you want to use mesh with them, you can do that as well because there is a hole for the vertical mesh to lead into. Uhm, you can also buy prebuilt coils for the DID and the other RBAs so, either way your good, I don't see the premade coils going anywhere... but, the prebuild coils for the DID and RBAs are more finicky than the vivi nova heads.

 

[Mbisjr]

Yes, the ody and Penelope are made by imeo and the ody goes with the ggts pv but there is no genesis style ody at the moment.

 

[vsummer1]

I have both the DUD/Griffin and the Chobra/cobra rebuildables. Hands down, the Chobra/cobra wins. As was stated before, if you can master the DID clone (dud) you can master anything, but the Chobra is a bit larger so easier.

 

[pandy_88]

i dont understand the rebuild part as well, i only use smoktech carto tank and vivi nova

 

[vsummer1]

i dont understand the rebuild part as well, i only use smoktech carto tank and vivi nova

In the vivi nova you unscrew the head and replace it with another, already built head. With a rebuildable, you tear that head apart and put new stuff in. I don't rebuild vivi novas because they make attomizers that are designed to be built by the user. You make a wick, then put the coil wire on yourself. If you mess it up, it will short out.

You need an advanced PV to use these, without protection you will fry your PV. For instance, don't use an eGo. You need a mulitmeter to read the ohms of the coil you make and to adjust the volts to the ohms so you won't "pop" the coil.

These are for advanced users, but that is a basic explanation.

 

[teoo]

the best are expensive but ......

 

[-ih-]

This has had good welcoming from mesh noobs and also from gurus of vaping.
Somnium Rebuildable Atomizer | Somnium mods

 

[proteckt3d]

I have both the DUD/Griffin and the Chobra/cobra rebuildables. Hands down, the Chobra/cobra wins. As was stated before, if you can master the DID clone (dud) you can master anything, but the Chobra is a bit larger so easier.

I'm trying to decide also. Is the wick hole bigger in the Chobra? When you say Chobra wins, does this mean I should only buy the Cobra clone and forget about the DUD?