Rebuildable atty help please

Status
Not open for further replies.

drkngl417

Full Member
May 22, 2012
13
2
54
USA
I just bought a Bulli Smoker A2 Classic and a "dream" fatty clone for dripping. I have been vaping for over a year and have rebuilt several coils on vivi heads and kangers. And they work great. My problems is when I build a coil for either my bulli or dream it has tons of vaper but the throat hit "Hits" like a freight train to where I feel like I am dying. I vape 12mg in all my other stuff, cartos, kangers and don't have a problem. Is there a way to calm the throat hit down on these to attys. I want a good dripping set up but I don't want to give up my flavor and nic level. Here is my break down. I vape 2ohm at 3.8 volts on a zmax with kangers and cartos and want the same vape with a rebuildable. Please any help or insite would be great.
 

artt

Ultra Member
ECF Veteran
Verified Member
Jan 14, 2011
1,137
230
71
michigan
I also use a Bulli Classic around 1.7 ohm ballpark. My diy juice is 20 mg with a 80% pg 20% vg and works great for me. You might try purchasing or if you diy try increasing the vg ratio. With the experimentation I've done there seems to be less throat hit with a higher vg content. Also, welcome to the forum.
 

NamVet68

Super Member
ECF Veteran
Verified Member
Feb 16, 2013
797
1,245
Orlando, Florida
home.roadrunner.com
As others have said - hot spot is culprit #1 ...(also if you get a metallic taste - make sure you don't have two wires touching)

Another often overlooked problem on an RBA that causes higher throat hit is lining up the air hole - line the air hole up directly with the wick and you will get lower TH.

That being said - a dripping atty will almost always give you a bigger throat hit anyway ....that's why many people like them.

Have fun....
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread