Rebuildable Dripper, but which one?

Status
Not open for further replies.

jwelborn

Senior Member
ECF Veteran
Verified Member
Mar 30, 2009
89
59
60
Cape Coral, FL
What is your recommendation on the nicest and easiest to rebuild dripper? I was successful rebuilding an IGO-L, but I want something a little more fancy in a brushed finish. Keep in mind that this was my first rebuild. Also, I prefer to use pre-coiled wicks and just plug and play. Quite frankly, my coil wrapping is nowhere close to good.
 

savagemann

Super Member
ECF Veteran
Verified Member
Jul 21, 2013
714
481
California East Bay
If you end up ordering through fasttech, make sure you add on a Phoenix V5 dripper to your order.
I've tried a bunch of their cheap drippers, and I really love this little thing.
Mine has 3 air holes, but they also offer it with 1 and 4 as well.
I wouldn't get this as the main part of an order, but for under 6 bux, this little thing is great.
Looks good too.
Brushed stainless and has holes for the wire with micro hex set screws. Comes with a wrench.
 

t8kiteasy

Ultra Member
ECF Veteran
Verified Member
Sep 22, 2012
2,690
1,980
59
virginia beach
The Igo-W is a stellar vape.You also have the Immortalizer,which is an exceptional vape.This would fit the bill for your fancy RBA,but there are no pre-built wicks for this one.The Nimbus at $65 is another great vape.

All of the RBA's that i listed are easily rebuilt but no pre-built coils made for them.If you need an RBA that prebuilt coils are made for then the SMOK RDA,otherwise known as the Octopuss RDA.Coils run $1.95 and not an expensive RDA either.
 

gokusnimbus

Senior Member
ECF Veteran
May 20, 2013
266
318
los angeles
ever since i got the Vicious Ant Cyclone (one of my first drippers), i havent been satisfied by any other dripper--in terms of looks, build quality, and performance. the small chamber makes for a full flavor vape. in terms of aesthetics, there is no other dripper like it. its made of 304 stainless steel--really hard steel. i've dropped it a bunch of times and it still looks like the day i bought it. it works best as a single coil rda. the posts are also drilled through for easy coil install--both round and ribbon. everyone raves about the nimbus, omega, patriot, helios, etc... but none of them come any where near the cyclone.

</2cents>

here's that beauty:

 
Last edited:

jwelborn

Senior Member
ECF Veteran
Verified Member
Mar 30, 2009
89
59
60
Cape Coral, FL
ever since i got the Vicious Ant Cyclone (one of my first drippers), i havent been satisfied by any other dripper--in terms of looks, build quality, and performance. the small chamber makes for a full flavor vape. in terms of aesthetics, there is no other dripper like it. its made of 304 stainless steel--really hard steel. i've dropped it a bunch of times and it still looks like the day i bought it. it works best as a single coil rda. the posts are also drilled through for easy coil install--both round and ribbon. everyone raves about the nimbus, omega, patriot, helios, etc... but none of them come any where near the cyclone.



</2cents>

here's that beauty:


Wow. I like the Vicious Ant Cyclone and have already watched a few videos. It looks very simple to rebuild and pre-made coils should just slide right in. Does anyone else have any recommendations on RBA's that are as easy to rebuild as the Cyclone?
 
Status
Not open for further replies.

Users who are viewing this thread