rebuilding

Status
Not open for further replies.

Vicshalls

Ultra Member
ECF Veteran
Verified Member
Oct 3, 2013
1,828
3,306
Houston, TX
i am fixing to start rebuilding my protank coils, i have minis now but would like to get a nicer rebuildable. i dont want to get into sub ohms and i dont want to spend 100 plus on a kayfun or z atty. do yall have any suggestions? i saw an aga t-2. what is the story with that one? i am wanting to get a higher capacity and 510 connection. thanks.
 

Vicshalls

Ultra Member
ECF Veteran
Verified Member
Oct 3, 2013
1,828
3,306
Houston, TX
I have an RSST and an AGA-t+. The RSST is way more forgiving. Easy build platform, spring loaded positive pin, insulated wick hole and a plastic bottom tank. Almost fool proof!

RSST? what is that? I will look it up i just am not good with all these accronims. I use them all day at work and my brain goes right to work stuff. lol
 

Vicshalls

Ultra Member
ECF Veteran
Verified Member
Oct 3, 2013
1,828
3,306
Houston, TX
I use micro coils and cotton on my PT II and it's a lot better than stock. I bought an IGO-I for dripping and really like it because it is easy to rebuild and has a small reservoir so I don't have to refill every few puffs.

Micro coils? Can you please explain that a little more. I am going tomorrow to get some wire and wick. Over the next few days i will be trying my hand at doing the pt mini. I am just getting a small amount just in case so i dont end up with tons of stuff all over the place and the threat of death for making a mess. I was going to get 32g wire since i read that was the best to start with. Do you recommend doing it another way? or using something diffrent?
 
Status
Not open for further replies.

Users who are viewing this thread