Tasty cakes!
Could go well with your new airflow control rings Rob
Sent from the zoo using Tapatypo 2
Reduced air chamber RM2 prototype
- Thread starter Xobeloot
- Start date
- th_trl_thread_readers 0
- Status
Tasty cakes!
Could go well with your new airflow control rings Rob
Sent from the zoo using Tapatypo 2
Vapor is significantly thicker. Flavor seems to pronounce the sweeter notes while remaining nicely balanced
LOL!
I made it out of 1/4" PTFE stock with an x-acto blade and a 9/64" drill bit.
I made it out of 1/4" PTFE stock with an x-acto blade and a 9/64" drill bit.
What's your source for PTFE stock? I found numerous places online, just curious if you buy it locally. BTW, I was looking it up and it said the temperature rating is 500F so NO dry burns with it inplace 
Do you feel the need to enlarge your air hole with this set up?
This is on the list of things to try!
Do you feel the need to enlarge your air hole with this set up?
This is on the list of things to try!
Last edited:
I run all my air holes at 1/16", so I really can not answer that question.
I buy my stock from McMaster-Carr Had some scrap left over from making my fuse blocks and decided to tinker a bit tonight.
I buy my stock from McMaster-Carr Had some scrap left over from making my fuse blocks and decided to tinker a bit tonight.
The center piece is slanted a bit downward. Should be able to make one as-is. Will rebuild this evening and report back.
- Status
