refilling ego-t tanks with syringe

Status
Not open for further replies.

JumpSteady

Senior Member
ECF Veteran
Mar 20, 2011
76
7
Pigeon Forge, TN
I have decided to start filling ego-t tanks with a syringe. The first time you pop the cap off its hard, then it gets easier and easier until the point where the cap comes off in the atomizer when you pull the tank out.

I went to tractor supply and picked up a couple of 3cc syringes for 29 cents a piece and a 5 pack of 16 gauge needles for $1.49. I blunted the ends myself with a grinder.
 

tearose50

Vaping Master
ECF Veteran
Verified Member
Feb 2, 2011
6,608
14,260
Tennessee :-)
Sounds like you got a good deal.

Some of the juice suppliers sell them already with the blunt tip needel, so it's easy to add one to an order.

I like a syringe too---because my caps would sometimes fly across the room to never never land. lol

Those "flux bottles" are pretty good too. Have a blunt tip needle on the bottle cap.
 

meeems

Ultra Member
ECF Veteran
Verified Member
Apr 4, 2011
1,882
3,302
Wisconsin
I have decided to start filling ego-t tanks with a syringe. The first time you pop the cap off its hard, then it gets easier and easier until the point where the cap comes off in the atomizer when you pull the tank out.

I went to tractor supply and picked up a couple of 3cc syringes for 29 cents a piece and a 5 pack of 16 gauge needles for $1.49. I blunted the ends myself with a grinder.


Thats what I should have done, should have got a syringe. the cap falling out inside happened to me twice. So with the syringe you just fill it upside down then? thru the small hole?
 

Erfmann

Ultra Member
ECF Veteran
Verified Member
Feb 27, 2011
2,023
2,680
Arizona
Thats what I should have done, should have got a syringe. the cap falling out inside happened to me twice. So with the syringe you just fill it upside down then? thru the small hole?

Yep, right thru the pierced hole that is made when you pop it on the atty...pop it on empty, then remove, fill, and pop 'er back on...
 
Status
Not open for further replies.

Users who are viewing this thread