Releaux RX 200 with Crown setup specific question

[ccfau44]

I recently took the suggestion of some of the more, more seasoned, experienced contributors and went from my Sigelei 150 tc which I had broken and bought the Ruleaux RX200 and kept my crown tank. I've noticed in the few day that I've had it that I get dry/burnt hits occasionally out of no where. If I loosen the tank from the mod a little bit it helps but I went got one day out of the coil I had just put in and two days after replacing that one, I just got a few burnt hits. I would say that the pack is full of duds but I used a coil from that pack on my Sigelei, before I broke it, that lasted 2-3 weeks. Has anyone else had this issue? I'm running about 65-75 watts with the .25 coils like I always have. Any help or tips would be GREATLY appreciated.
Thanks!!

 

[rice721]

I know this may sound trivial but did you prime / wick the coils properly?

[edit] also check to see your mods reading the right resistance of 0.25

 

[ccfau44]

I know this may sound trivial but did you prime / wick the coils properly?

[edit] also check to see your mods reading the right resistance of 0.25

Thank you for your reply. Yes I've been using the same tank for a while and I'm very thorough on how I prime my coils. Mod is reading perfect and volts are on point also. For whatever reason the last two I've used have done the same thing after about a day of use. I'm going to try a coil out of another pack I have and see if that helps.

 

[smacksy]

I have the Crown .25 on the RX200 with the .25 coil l vaped at 62w., also had the .5 coil at one time on the other RX at 50w, both vaped good without issues But since getting the Griffin RTA's these Crowns have been made suddenly obsolete, they are back on the shelf... Good luck with your Crown[emoji14]

Sent from my XT1080 using Tapatalk

 

[Mowgli]

My DIY is sweet and pretty gunky so I scrape out the gunk at about 30ml and every few fillups afterward.

I think it also "glazes" the cotton at the holes so I poke through the holes with a map pin and rough up the cotton there when I start getting dry hits. I also poke down to the holes from the top. It works for me.