Hello.. I posted this question in the "ask the vets" section but it might get rejected since it's not in the correct forum area.
so sorry mods...
but i bought a VV a few weeks back along with some Aspire BDC ETS cleros.. the heads might be running on it's last legs..
i like the ETS so i am going to be buy more heads but i am confuse don which OHMS to get..
i found a statement on another thread saying "The Aspire is a dual coil. Dual coil in parallel. So if you have two 3.6 ohm coils you get a total resistance of 1.8 ohm."
so does that mean i should be getting the 1.8ohms instead of the 2.2ohms?
and how come in the V/W/Resistance chart 1.8ohms is in the RED for ~4.3v+.. i set my volts between 4.3-4.9v.. should i still get the 1.8ohm heads?
if my vv battery runs out i use my kanger ego batteries as backup... are the 1.8ohms still good for that as well?
Thanks
so sorry mods...
but i bought a VV a few weeks back along with some Aspire BDC ETS cleros.. the heads might be running on it's last legs..
i like the ETS so i am going to be buy more heads but i am confuse don which OHMS to get..
i found a statement on another thread saying "The Aspire is a dual coil. Dual coil in parallel. So if you have two 3.6 ohm coils you get a total resistance of 1.8 ohm."
so does that mean i should be getting the 1.8ohms instead of the 2.2ohms?
and how come in the V/W/Resistance chart 1.8ohms is in the RED for ~4.3v+.. i set my volts between 4.3-4.9v.. should i still get the 1.8ohm heads?
if my vv battery runs out i use my kanger ego batteries as backup... are the 1.8ohms still good for that as well?
Thanks
Last edited:
