Resurrector on Vaporescense BFT

[rockhounds5]

I see posts on the resurrector carto on Vaporescense BFT, but didn't see anything about leaking like I've experienced on the dual coil cartos on the BFT. I also don't like the super hot vapor coming off the dual coils. Are there single coil long cartos (48mm) that would fit on the BFT? I also tried the 3.7 battery on the LR Boges and it's too cool. I guess I need a provari to get in between voltages, unless there is a 5v battery out there that would fit my Bullet.

 

[atavanhalen]

I see posts on the resurrector carto on Vaporescense BFT, but didn't see anything about leaking like I've experienced on the dual coil cartos on the BFT. I also don't like the super hot vapor coming off the dual coils. Are there single coil long cartos (48mm) that would fit on the BFT? I also tried the 3.7 battery on the LR Boges and it's too cool. I guess I need a provari to get in between voltages, unless there is a 5v battery out there that would fit my Bullet.

The single coils(resurrectors) are the same length as the dual coils. I agree with your comment about the boges not hitting hard enough at 3.7, I like the resurrectors much better in that regard and the flavor is pretty close to a boge, the one issue I have with them is that I find a bad one in 1 out of 5, it just sucks because you do not know its bad until you fill it with juice and vape it for a bit because the bad ones i have found ohm out just fine they just taste really bad. All in all I think it is my favorite carto atm but always looking for somethin slightly better.

 

[rockhounds5]

Vaporescence tells me they will have the single coil 48 (45?) mm in soon, so I will probably go there next week to see if these work. THey really worked with me last week trying to get the leaking stopped, but we wen through 3 cartos with various sized holes or slots to no avail. They all started gurgling and then leaking. Most frustrating after spending $40 on the BFT, which, by the way holds a lot of liquid that I had to dump into a smaller tankinator to avoid waste. Could have used a syringe.

 

[datacreek]

Resurrectors work great for me. Using a Liquinator.

 

[BiancaMontgomery]

When you get your single coil Resurrectors try punching just one hole in them...or if you still have dual coils, try just one hole on those. That's all either of them need. Two is just overkill with them. And there is a 5v battery (requires a special charger) that will work in your Silver Bullet: NiMH Batteries and Chargers

 

[rockhounds5]

Cool. Think I'll try that 4.8v. Thanks!

 

[rockhounds5]

Also, I do have a drill press with some small diameter drill bits. Anyone have experience punching holes in the cartos with a drill press? I need to look at my drill bit set to see how small a bit I have. After my experience with the leaking, I'm wanting to put the smallest possible hole it it.

 

[classwife]

for the holes...I use this :
Stanley Bostitch :  16-058  - 

 

[atavanhalen]

Resurrectors work great for me. Using a Liquinator.

Me too, and i use a slot not a hole but others mileage may vary.