My rsst will not fire im trying it on a ego c twist I have no way of checking ohms right (vamov3 in the mail) I have rebuilt coils before on my ego c twist can any one please help
depending on the gauge of the wire, and mesh it might be too low ohm for the ego twist to fire. I don't know the ohm limit on an ego twist but someone here knows, probably 1.2
What gauge is your wire? I also suspect you are below the 1.4 ohms or so that the eGo Twist will fire. Does the button flash a few times when you first try it? You can also buy a cheap DMM from eBay or Amazon. I paid about $10 for mine and it works well enough for this use.
Never build a coil and try using it without knowing the EXACT resistance
Never try using a low ohm coil on a tiny EGO style Battery - 1.8ohm is about it
Never try powering a Mesh wick coil on an EGO - any short can kill the battery
You should at Minimum have a multimeter to check ohms and a cheap mech mod to pulse the coils in preparation for use as well as a decent power mod for use.
Please put the RSST in a safe place until you have everything and can do this safely.
order some 28 Gauge Kanthal A1 wire and do a 1.4 ohm wrap for the Vamo. Probably a 5/6 wrap. Even then, the Vamo may show short during the pulse process. If so, twist the wick back and forth and read resistance/pulse again until it holds steady. Then add liquid and give it a try.
I got it working turns out I left the threaded sleeve that goes around center pin out when I put it together but even on a ego c twist this thing kicks ... so much intense flavor
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.