Russian 91 problem

[rastapete69]

After liking my kayfun clone so much, I went ahead and got a Russian 91

although much is the same, I noticed the deck where the positive screw goes was moving.

after taking off the center pin, there is a screw that comes out and allows you to tighten up the deck.

After doing this, the center pin was too far in to allow it to fire.

It seems like the post is 1mm short unless I am missing something.

My temporary remedy was to put 2 o rings between the screw and post, but still do not have the positive deck as tight as I think it should be

 

[Technonut]

Here is some info...

Ezig have just got in touch and resolved the issues. If anyone else has the same problems:

1) The center post in the Russian DOES have an adjustable pin. However, it's torqued so hard in the factory that it may be seized when it arrives. Simply dissassemble, push an end of the included screwdriver through the hole in the middle of the post, and unscrew the base screw. It takes a bit of force, but it will start to unscrew.

Once it has been unseized, it will forever do what it's supposed to. Center post issue: sorted.

http://www.youtube.com/watch?v=TctmMqxe2qs

 

[rastapete69]

Wow! I am so grateful for this video and glad I'm not alone.
I spent a long time messing with this setup and ripped out a few coils before realizing the pin was not sticking out enough
My temporary solution was to add a second o ring between the screws, but this makes more sense