Russian 91% RTA

Status
Not open for further replies.

smacksy

Ultra Member
ECF Veteran
Aug 17, 2014
2,330
2,100
Alexandria, Louisiana USA
I got my first Russian to use on the Provari and after reading many posts on how to wick and coil it I must say I'm impressed. Great flavor and vapor produced, just short of dripping, with a 1.1 ohm 26g coil and cotton wick..trick for me was not using too much cotton and don't block the juice channels tucking the ends down to the deck.
No leaks and the adjustable pin let's me use the Tatroe ring making it sit flush on the Provari..air is controlled by a little screw that I have set wide open..for me its such a great rebuildable tank atomiser I'm thinking about getting another for my mech mod and build it with a sub ohm coil. Lazy man's dripper maybe? Lol

from Droid Maxx using Tapatalk
 

Kloudz

Ultra Member
ECF Veteran
Verified Member
Aug 30, 2014
1,075
1,267
Phoenix, Az
www.youtube.com
I've been reading up on RTA's and it's a tough decision for me, kayfun or Russian?
Glad you are liking your set-up.
The only thing that worries me is the air draw part, I run a Aerotank MEGA on my Provari and have it as wide open as possible, just really unsure of how the draws are on the Russians?
 

smacksy

Ultra Member
ECF Veteran
Aug 17, 2014
2,330
2,100
Alexandria, Louisiana USA
Well the draw on the Russian is way better than any Areotank I've tried..the Russian has adjustable air control and keeping the coil/cotton wick about 1/4" above the hole in the deck also helped with more air..also I use a bigger bore drip tip that also improved the draw to the point I can do easy lung hits with it..

from Droid Maxx using Tapatalk
 

smacksy

Ultra Member
ECF Veteran
Aug 17, 2014
2,330
2,100
Alexandria, Louisiana USA
Well the draw on the Russian is way better than any Areotank I've tried..the Russian has adjustable air control and keeping the coil/cotton wick about 1/4" above the hole in the deck also helped with more air..also I use a bigger bore drip tip that also improved the draw to the point I can do easy lung hits with it..also after trying different gauge wires on the Russian I've found 26g to be the best performing on the VV Provari.. 7/8 wraps on a 3mm bit at 1.1-1-2 ohms produces a good thick vape for me..good luck!

from Droid Maxx using Tapatalk



from Droid Maxx using Tapatalk
 

smacksy

Ultra Member
ECF Veteran
Aug 17, 2014
2,330
2,100
Alexandria, Louisiana USA
Well the draw on the Russian is way better than any Areotank I've tried..the Russian has adjustable air control and keeping the coil/cotton wick about 1/4" above the hole in the deck also helped with more air..also I use a bigger bore drip tip that also improved the draw to the point I can do easy lung hits with it..

from Droid Maxx using Tapatalk
Update:
Now my favorite setup is the Atlantis sub tank...puts my R91 on the back burner for now...lol
 
Status
Not open for further replies.

Users who are viewing this thread