The costs of running this huge site are paid for by ads. Please consider registering and becoming a Supporting Member for an ad-free experience. Thanks, ECF team.

Russian 91% Leaking

Discussion in 'Rebuildable Atomizer Systems' started by Snaeem155, Sep 1, 2014.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Snaeem155

    Snaeem155 Full Member

    Jan 24, 2013
    Hi All,

    I seem to be having a leaking issue through both the air hole and the air adjustment screw.

    All the o rings are seated correctly and my wick is fine, not blocking the juice channels at all.

    Quite stumped with this one !

    It's a authentic russian 91% with a 2.8ohm microcoil with organic cotton wick.

    Any ideas?
  2. State O' Flux

    State O' Flux Vaping Master Verified Member ECF Veteran

    Jul 17, 2013
    See item #'s 4 & 8, and read the "boundary layer" hyperlink in item #5... here.
  3. heyilikethis

    heyilikethis Senior Member

    Jun 21, 2014
    coil could possibly be too close to the center airhole, wicks could be too short or too dense, center post may not be tight enough-the one that holds the positive block in place(this is a common issue with russian 91%'s), other than that i can only think that o-rings are bad or something is not sealing properly, lotsa things to try :p, also hopw are u filling the atty
  4. dice57

    dice57 PV Exporer/Juice Saucier Verified Member ECF Veteran

    Sep 1, 2013
    Mount Vernon, Wa
    The main cause of leaking/flooding, on the Russian is improper filling technique, if top filling, it's easy to pressure flood the chamber, if filling through the screw hole, one can easily push juice into the chamber. Usually it can be vaped off, or blow cleared into a tissue.

    Also, if using cotton, to much down in the juice deck can super flood it too. Hemp, Ramie and Rayon don't seem to cause the same problem, but with cotton once had to much in the Russian and the entire chamber was flooded.
  5. Snaeem155

    Snaeem155 Full Member

    Jan 24, 2013
    I always fill from the bottom.

    I made a new build and it worked fine for a few minutes and the gurgling is back.

    I think I lose the vacuum which leads to leaking but I cant figure out where it is coming from!
  6. ForeverDiving

    ForeverDiving Super Member Verified Member ECF Veteran

    All my Kayfun leaks have been from faulty vacuum, nearly all times due to improper seal of the small oring between chimney and top cap. Can you try a different oring?

    PS, it's issue #8 (last) on the link posted up-thread.
Thread Status:
Not open for further replies.

Share This Page