Hey guys just wanted to ask/share/inquire:
1. Anybody know what the info on the safety cut off is?
2. I got the corolla and the firing response is pretty slow.... I use it for my genesis takes 1-2 seconds to fire up anybody else got that issue?
3. Last question is that I usually end up needing to press the fire button pretty hard for to fully fire anybody else?
Just wondering if these are manufacturing or the thing is built that way.
Other than that its a pretty good device, been pretty happy with it past couple of days. Those top three are the only issues I have with it.
Cheers!
Ok..Here goes....
The Corolla is a mechanical mod. There will be no safety cutoff..
The reason your getting a slow fire is probably due to :
A. I relatively high ohm coil. A mech will fire a rba best (quick response) at 1.1-.9 ohms..
B. Are you using a UN protected Batt? The Panasonic NCR18650PD is an excellent choice:

These bad boys carry a 2900mah life with a 10amp discharge capability. Yes I know most Mech manufactures say to use "Protected Batts Only", but for God's sake.. don't listen to that. Put a vape safe in it, and load it up with some muscle.
Of course the ever popular AW IMR's are excellent, along with the soon to be discontinued Panny CGR's....
C. It is not uncommon for Chinese Mechs to be in need of a little "caressing" to make them hit like a champ. The firing pin and Batt post could probably be in need of a sand job, to get rid of the chrome or other plating. In the mechanical world, everything revolves around "conductivity"....Voltage drop at the 510 is a major hurdle and problem with Chinese Mechs. However, if a little time is spent with them, they can be made to perform (and look) like a MOD costing 10 times as much:

*Danno: Lets change that description "Chrome over Copper"..please kind sir...as much as I would LOVE for it to be !!!
Last edited: