Scared of device

Status
Not open for further replies.

Mimikim1234

Senior Member
ECF Veteran
Verified Member
May 30, 2013
269
316
Chicago
I posted this in another user's smok m80 thread. I hope it's ok to post here too. I'm really concerned, and would like to know if this has happened to anyone else. Here is the post unaltered:

I loved the device at first, but now I am scared to use it. I had an Atlantis 2 on it, and at first, it consistently read the ohms as .39. Then it started jumping all over the place from puff to puff. It went anywhere from .39 to 1.2, always different with each puff. At one point, it even changed the watts on its own (it kept dropping them down from around 30 to around 25; it did stop doing this). So I put my kanger Subtank nano on it, at 24 watts. It read anywhere from .55 to 1.5. Then, on the last puff before I shut the device off, it read 2.62 and burned my throat really bad at 24 watts. Since it reads different with each puff, and I don't get the new reading until after I've hit the button, I cannot check what it will be before I've inhaled. I've been vaping for years, and never felt anything like this. My chest hurts, and my throat feels very sore. Contacting the vendor now, but I don't know that I would even want to use one ever again. This was scary for me. The device had the updated chip, and was not even used for more than a half a charge. (The two tanks are fine on my other mods.)

A moment agoEditReport
+ QuoteReplyTop
 
  • Like
Reactions: SissySpike
Status
Not open for further replies.

Users who are viewing this thread