Smallest repairable atomizer?

[santo19586]

this is awesome , thanks for sharing..

A how-to finally:

RCA Atty - Imgur

I had to use imgur because 83 pics were nessesary, to make this as easy as possible. Enjoy

 

[thejager]

this thread makes me wish i had these skills... sigh

 

[TennDave]

Will any of these work on a bottom feeder like a Reo?

 

[zerocool5878]

Will any of these work on a bottom feeder like a Reo?

The RCA mod will not work with a bottom feeder because the hole is filled with the sewing needle and solder. Not sure about the other ones

 

[meatsneakers]

The RCA mod will not work with a bottom feeder because the hole is filled with the sewing needle and solder. Not sure about the other ones

If you take a look at my tutorial further up the page, you'll see the way I attach the needle allows you to use it with a bottom feeder.

 

[par292]

that is my ideal atty rebuildable and work on a bottom feeder.. that would be awsome

 

[santo19586]

well, just got mine done, it was easy to follow the tutorial, thanks for posting.. this repairable atty rocks!

 

[urquidezj]

pics or it didnt happen lol

 

[santo19586]

ok here is my first pic, so it did happen. lol

 

[santo19586]

No nuts 0-80 screws 16 g tubing and tapped it.

hi there,
where did you get such a small tap for the 16ga tubing?

 

[santo19586]

i used two sewing needles for the posts, really like the tubeing and screws though, i got to make one with the screws,.
on another note ,
@urquiedezj how are you to get really good close-up photo's osf your atty?

 

[santo19586]

a blurry close-up

 

[Killjoy1]

hi there,
where did you get such a small tap for the 16ga tubing?

If you google "0-80 tap" you'll find plenty of places to buy one ;-)
for ex: Tap 0-80 (k+s435) K-S Tap and Die
Or if you have a local Grainger/McMaster/Fastenal/etc store you could try there

 

[urquidezj]

My shop has em lol but mcmaster Carr carries em. They also carry the 16 g ss tubing. Just know that u can't solder into ss with the soldering iron u will need a torch with silver solder and flux paste.

 

[urquidezj]

I use my EVO 3d with good lighting for pics.

 

[Sicarius]

Been playing with some left over atty spares

 

[BuzzKilla]

how are you to get really good close-up photo's osf your atty?

check to see if your camera has a macro setting and turn it on, usually indicated with a little flower icon.
Good for close-ups

newer smart phones should also have a macro option in the focus settings to taking close-up pics.

 

[SammyT]

I am going to try this out. One question... why in the tutorial do you put heatshrink over the air holes in the atty connector and drill an air hole in the sleeve? will it not work as intended? I find the draw is perfect for me with the the two stock air intake holes. TIA and thanks for the how to meat! It definitely makes it easy and is VERY straight forward, the best illustrated how to I have seen!

 

[bushmasterar15]

Great job on these.

 

[meatsneakers]

You can use the airholes, but I find I get a better draw from using a larger hole closer to the coil. You can give it a shot without the hole and see how you like it - you can always add the hole later.