Smok xcube 2 voltage problem

Status
Not open for further replies.

Petethemonkeyface

Full Member
May 10, 2016
6
1
40
Same problem in power and TC modes? What about TC using different types of wire- any difference? If you remove then replace the battery, does the mod work better?

Same problem in both modes. No difference between wires on TC and nothing difference with batteries.
Weird cuz it reads ohms and show that batteries have life and everything else looks to be OK, but voltage is 0.15.
 

cobalt327

Ultra Member
ECF Veteran
Verified Member
Nov 1, 2012
1,479
2,116
USA
I've seen where on some mods the 510 assembly has spun inside the housing of the mod, like from tightening an atty too hard, and that caused a short internally when the wires twisted together. I'd also check to be sure the 510 pin isn't touching the side of the 510, and that the 510 pin moves freely up and down (isn't stuck all the way down, in other words), or that nothing has dropped down inside the 510 causing a short.
 
Status
Not open for further replies.

Users who are viewing this thread