Hi all Vmax users.....wow! Great vape! I am posting for Vapn. He was so kind to answer my questions as I've been a lurker here for a couple weeks now. I have to say that I'm afraid the batts I got are not holding the charge or I just shouldn't be using them with the DCT carto that comes with the tanks. The charge only held for approx 1 1/2 hr and then metered at 6.0 volts and stopped working. The beginning batt. volt metered on the Vmax at 7.7 volts,not sure why? I'm not sure what's going on with it. It vaped heavenly for that 1-11/2 hrs,but I know I should get more out of it than that. I have some fusions here that are 2.9ohm and will shortly check those to see if the prob. is the battery or the carto. Any suggestions?
I got the SS,and it is beautiful. There is no smudging at all; it's very sturdy and a bit heavier than I thought it would be but comfortable enough to hold for petitie female. There is a jiggling from the LED area,but from what I've read this was common in the first model or two,but I thought that it was remedied in this newer one. Can this be fixed or could it cause problems down the line?
I'm very impressed so far with this device as when I was vaping ,it was so much more satisfying than the Twist I've been using for a while. I think it's more comparable to my Darwin vape experience.
Overall,I'm impressed,but the vape time and the inablity to use the DCT at this point has me thrown off a bit. I hope that the fusion carto will change the low vape time on both the batt and the blinking when it got to 6.0 v on the battery,where the device totally stopped working.
I will report back as to how it goes with the 2.9 fusions....
Thanks Vapn for all of your support and time you took to answer all of my questions.