Dirk, how would you describe the quality of the end cap
threads on the Z?
They're a little bit shallow so getting the end cap on is a task - no squeaking though.
They have to be good for the chroming process.
*edit*
Comparing it to my broken steel Vmax, it's
exactly the same tube and end cap so the threads would be identical also.
The only difference is that the board must be a tad longer, can't see a ground wire also -the board must be ground directly to the tube somehow. This is a
much better arrangement than the wire ground on the Vmax as it was a weak point.
If combine this with the new board button plus new supplier for the electronics then you're on a winner.
The whole thing performs
really well and feels very solid.
