I just purchased a snow wolf 75w mini from a local b&m, I can take a few drags, (4 or 5) then on the screen it will show "high temperature" preventing ,me from firing the device. right now I am running an rda at .26 ohms at about 60 watts, and am using an mxjo 18650. is my mod safe? is this normal? thank you
snow wolf 75w mini saying high temperature
- Thread starter dallyllama
- Start date
- th_trl_thread_readers 0
- Status
Surprised this post sat so long unanswered.. 
Something is not right with your kit. The board in the mod is reading that it is too hot. Should not be happening.
Take it back to the place of purchase. Have them test it. Most shops will cover purchases for X number of days on their return policy for manufacturing defects, which it sounds like you have.
Something is not right with your kit. The board in the mod is reading that it is too hot. Should not be happening.
Take it back to the place of purchase. Have them test it. Most shops will cover purchases for X number of days on their return policy for manufacturing defects, which it sounds like you have.
I have the same mod. If my coils are too close to the exterior of my atty I get this error. Move your coils closer to your posts and see if it errors. I'm running a .23 build on a Stumpy right now with zero errors. Is the exterior of your atty heating up? I can easily ump up to 60 watts but it will burn this juice. Make sure you have zero shorts or hot legs as well. Make sure you don't have a hint at the slightest short.
- Status
Similar threads
