So frustrating! Itaste

Status
Not open for further replies.

mgavilondo

Super Member
ECF Veteran
Verified Member
Oct 19, 2013
308
1,712
Day started off innocently enough.. Getting ready for work. Got my itaste in my bag just screwed on the aspire, ready to fire up and get nothing but a NON... No biggie I can adjust the pins a bit but usually there's no issue with the aspire not firing.. Had it a few times with the MVP but adjusted the pin and it was fine... Now I'm in he bf van driving to the station wiggling the pin and still not firing.. So I get the tweezers and start doing it to the pin in the aspire and suddenly the pin pops out.. I'm looking for it and still can't find it:(. Is that piece part of the head or the aspire? Hate have to replace the aspire but the issue here seems to really be why the itaste and sometimes the MVP don't connect well ... I'm getting tired of dealing with something so basic... Ughhhhhh!


Sent from my iPhone using Taptalk
 

Pinggolfer

Vaping Master
ECF Veteran
Verified Member
Jul 28, 2013
6,890
18,791
The Clemson Tigers State
Day started off innocently enough.. Getting ready for work. Got my itaste in my bag just screwed on the aspire, ready to fire up and get nothing but a NON... No biggie I can adjust the pins a bit but usually there's no issue with the aspire not firing.. Had it a few times with the MVP but adjusted the pin and it was fine... Now I'm in he bf van driving to the station wiggling the pin and still not firing.. So I get the tweezers and start doing it to the pin in the aspire and suddenly the pin pops out.. I'm looking for it and still can't find it:(. Is that piece part of the head or the aspire? Hate have to replace the aspire but the issue here seems to really be why the itaste and sometimes the MVP don't connect well ... I'm getting tired of dealing with something so basic... Ughhhhhh!


Sent from my iPhone using Taptalk

Have not used the Aspire only Kangker ProTanks and Min ProTanks and both my VV-3 and MVP 2 work fine. If you are screwing the Aspire down too much you may have pushed the fire pin on the MVP down some. With a tiny screwdriver you can gently move the fire pin up a bit.
 
Status
Not open for further replies.

Users who are viewing this thread