So I made myself sick

[Ryedan]

Even if the coil gets beyond the vaporization temperature of the nic-goo, the goo will not continue to heat above its vaporization point without more heat input. Because the vapor is immediately pushed away from the coil (as you can easily observe when firing an atty with the coil exposed) the vapor will not get scalding hot. It's the same reason you can put a torch to a block of ice, and the ice will stay at 32 degrees until it is melted, and then the water, IF heat is still applied, is able to heat up.

So even if one coil were able to get way hotter than another, with appropriate airflow, the temp of the vapor would not likely be substantially different. Yes?

View attachment 309932

You've got it Mitey. Great diagram! As long as the coil is wet, the coil will not get much hotter than the liquid at phase change to vapor. Having good air flow on the coil also helps keep the vapor moving and the coil cool.

Now, once the coil gets dry, all bets are off and the temperature is going up, fast. If this happens to me I fix it right away so the coil stays wet at the power I'm using. Burnt hits are not safe to vape.

 

[Ryedan]

Experience that it is incorrect, at the very end of a vaping drag the temp spikes really fast as the e liquid cannot keep up with demand of the coil.

Why are you vaping a setup which does not wick juice fast enough? That is not safe. Burnt juice can create acrolein. Check out the health risks of this stuff. As I said, I always fix my setups at the first sign they burn juice so I only get a couple of minor inhales of it at most.

Vape safe

 

[Sucker_dad]

I lol'd at this...

You're welcome.


Sent from my intestines using my linear gas accelerator.